Imperva Cyber Community

 View Only
  • 1.  How to configure SNMP

    Posted 04-12-2022 02:47
    Dear all, 
    I can find a few guide about configuration SNMP as bellow
    Imperva Documentation Portal
    Imperva remove preview
    Imperva Documentation Portal
    View this on Imperva >

    Imperva Documentation Portal

    but i don't know how to configure send SNMP message to SNMP server (because i cannot see any step about add a snmp server on this guides). at the moment, i need send some important information such as CPU, status up/down, Throughput of each interface... on the gateway to snmp server (solarwinds).

    Can someone help me? Thank you so much !


    Ngo Dinh
    Security Engineer

  • 2.  RE: How to configure SNMP

    Posted 04-12-2022 03:15

    SNMP is basically pulling method, when server need some information, request to client.
    So you need to find how to pull information in server.


    Byunguk Jung

  • 3.  RE: How to configure SNMP
    Best Answer

    Posted 04-12-2022 20:21
    Edited by John Thompson 01-15-2024 17:49
    This document talks about sending SNMP traps (snmp messages from device to snmp server/ monitoring tool) using followed actions.


  • 4.  RE: How to configure SNMP

    Posted 04-04-2024 10:37

    Hi Dinh Ngo Van,

    Could you please let me know if you are able to configure SNMP traps from MX, GW, DRA to Solarwinds for monitoring CPU, status up/down, Throughput of each interface, filesystem space, etc.

    Kindly help to share steps for it.

    Thanks in advance for your help.

    Rakesh Chinta
    Senior Cyber Security Consultant
    Ensign InfoSecurity (Systems) Pte Ltd.