Imperva Cyber Community

communities_1.jpg
 View Only

  • 1.  Virtual Device Node setting for V13.6 to V14.8 Upgrade

    Posted 08-24-2022 20:04
    Edited by Sayed Ali 08-24-2022 20:07
    Hi All,

    Can anyone clarify on the this Virtual Device node change procedure given in the guide. Its basically asking to change it from IDE to SCSI , however VM infra teams says that it cannot be changed with just drop down selection , rather we might have to rebuild the machine.
    At the moment Virtual appliances are having virtual device node IDE.
    Updating Virtual Hard Drive Settings before Upgrade | Imperva

    Regards
    #DatabaseActivityMonitoring

    ------------------------------
    Ali 
    ------------------------------


  • 2.  RE: Virtual Device Node setting for V13.6 to V14.8 Upgrade

    Posted 08-25-2022 01:18
    Hello Ali,

    Thank you for the post, you will get the option to change the Disk mode once the VM is turned off, below is the screen shot,



    ------------------------------
    Syed Noor Fazal
    Product Support Engineer
    ------------------------------

    Original Message


  • 3.  RE: Virtual Device Node setting for V13.6 to V14.8 Upgrade

    Posted 05-30-2023 03:23
    Edited by Sankar Ganesh 05-30-2023 03:23

    Hi Ali,

    I'm eager to know the result, Since I'm also in same situation now.

    Were you able to change the  Virtual Device node  from IDE to SCSI after powering off the VM Machine.

    Once you changed it to SCSI in drop down menu, any rebuild of the machine done?

    Kindly revert it will be helpful for me.




    ------------------------------
    R. Sankarganesh
    ------------------------------

    Original Message


  • 4.  RE: Virtual Device Node setting for V13.6 to V14.8 Upgrade

    Posted 06-08-2023 02:03

    Hi Ali,

    I'm eager to know the result, Since I'm also in same situation now.

    Were you able to change the  Virtual Device node  from IDE to SCSI after powering off the VM Machine.

    Once you changed it to SCSI in drop down menu, any rebuild of the machine done?

    Kindly revert it will be helpful for me.



    ------------------------------
    R. Sankarganesh
    ------------------------------

    Original Message