Hello Ganesh,
As per my knowledge there are two ways how you can look for gateway mode:
- CLI
- Management Interface
------------------------------------------------------------------------------------
CASE 1 - CLI
As I know via CLI are two methods:
Method 1: impctl gateway show
The output in my lab as below:
Another way how you can check the gateway via cli is by following the steps below on the Method 2:
>> impcfg
>> Manage SecureSphere Gateway
In this case the WAF One Box is in Bridge IMPHVA Mode:
Output:
If you want to change the mode of the Gateway:
>> Manage SecureSphere Gateway
>> Change Operation Mode
Output:
CASE 2 - Management Interface
You can find on the following path:
Main > Setup > Gateway
I hope it will help and is the desired output.
Kind Regards,
------------------------------
Olgerta Prendi
Cyber Security Specialist
S&T AG
Tirana
------------------------------
Original Message:
Sent: 10-20-2022 01:29
From: Ganesh Thube
Subject: How to check gateway operation mode
Hi Community,
Hope you guys are doing well.
Could you please tell me how to check whether the gateway is running in sniffing mode or in Bridge mode.
I have tried running command "impctl gateway show" as stated in https://support.imperva.com/s/article-items?articleId=e21f3097
But i did not found the desired output.
Is there any other method through which i can check?
Thanks!
#DatabaseActivityMonitoring
------------------------------
Ganesh Thube
Technical Consultant
Meta Infotech Pvt. Ltd.
Mumbai
------------------------------